Niles Audio HDL-6 Uživatelský manuál stáhnout pdf (Strana 7)

Avoiding Interference

Speaker wires can act as an "antenna" for electrical noise. Locating

speaker wires too close to a light dimmer or switch may cause a

"buzzing" or "popping" sound to be heard through the speakers.

If you must locate the HDL-6 wiring near electrical devices, route

the speaker wires several feet away from the electrical wiring.

Using the HDL-6 with Tube-Type Amplifiers

Virtually all tube amplifiers must have a load connected at all

times. If the amplifier to be connected to the HDL-6 is a tube

amplifier, be sure to always have at least one pair of speakers

switched on at all times. An alternative is to permanently connect

a 150 ohm, 5 watt resistor across the tube amplifier's output in

parallel with the HDL-6. See (Figure 1) on next page for hookup

diagram.

IGH

EFINITION

PEAKER

ELECTION

YSTEM

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Žádné komentáře

Niles Audio HDL-6 Uživatelský manuál Strana 7